% generated by scripts/make_component_docs.py -- do not edit. Put hand-written notes in docs/components/notes/AirbridgeMultiFace.md (included below). # AirbridgeMultiFace PCell declaration for a multi-face equivalent for an airbridge. **Source:** KQC (KQCircuits). **Category:** airbridge. **Module:** `kqcircuits.elements.airbridges.airbridge_multi_face`. See also the [catalog](../CATALOG.md). ## Pins ![Pins of AirbridgeMultiFace](../../images/components/AirbridgeMultiFace.png) Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm. | pin | x (µm) | y (µm) | direction (°) | a (µm) | b (µm) | purpose | |---|---|---|---|---|---|---| | `a` | 0 | 22 | 90 | 10 | 6 | CPW end; LOM node `w` | | `b` | 0 | -22 | 270 | 10 | 6 | CPW end; LOM node `w` | a, b: CPW centre width and gap where the pin declares them (`–` = not declared). Position and direction are in the cell's own frame (`at=(0, 0)`, `rot=0`). ## Parameters | name | default | unit | description | |---|---|---|---| | `a` | `10` | μm | Width of center conductor | | `b` | `6` | μm | Width of gap | | `r` | `100` | μm | Turn radius | | `bridge_width` | `40` | μm | Bridge width | | `pad_length` | `40` | μm | Pad length | | `bridge_length` | `44` | μm | Bridge length (from pad to pad) | | `airbridge_type` | `"Airbridge Multi Face"` | – | Airbridge type | | `include_bumps` | `true` | – | Include bumps | | `ubm_diameter` | `40` | μm | Under-bump metalization diameter | | `bump_diameter` | `25` | μm | Bump diameter | | `bump_type` | `"Flip Chip Connector Dc"` | – | Bump type | Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows. ## LOM model The cell contributes to the lumped model: - no lumped branches Nodes: `w`. ## Simulation export notes - C2: indium bump in a one-face simulation is a PEC pillar to the top of the box (status: fixed; fix in sim_tools/builder.py) ## How to use In Python: ```python from quantcore_circuits.designer import Designer d = Designer("demo", box=(0, 0, 7500, 7500)) d.add("U1", "AirbridgeMultiFace", at=(3750, 3750), a=10) # parameters: see the table above d.add("PAD", "BondPad", at=(1125, 3750), rot=270) # a launcher to connect to d.route("L1", "PAD.a", "U1.a") # a CPW from the pad to the pin ``` Pin names go into `d.route(...)` as `INSTANCE.pin`, and into `snap=` / `to=` when placing. From the shell: `qcc components AirbridgeMultiFace` lists the pins; add `--schema` for the parameters. In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.