% generated by scripts/make_component_docs.py -- do not edit. Put hand-written notes in docs/components/notes/JJFingerBent.md (included below). # JJFingerBent Bent junction finger with its holder (legacy "JJ_finger Bottom"), on ``SIS_junction_2`` (4/0). **Source:** Quantcore. **Category:** shape. **Module:** `quantcore_circuits.layouts.junctions.jj_fingers`. See also the [catalog](../CATALOG.md). ## Pins ![Pins of JJFingerBent](../../images/components/JJFingerBent.png) Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm. No pins: this cell has no ports. Place it with `at=` / `rot=`. ## Parameters | name | default | unit | description | |---|---|---|---| | `a` | `10` | μm | Width of center conductor | | `b` | `6` | μm | Width of gap | | `r` | `100` | μm | Turn radius | | `finger_width` | `0.2` | μm | Finger width (legacy finger_width) | | `pad_width` | `0.5` | μm | Pad width (legacy pad_width) | | `finger_length` | `1.5` | μm | Finger length (legacy finger_length) | | `window_width` | `10.0` | μm | Window width (legacy width) | | `negative` | `true` | – | Negative: window minus finger (legacy negative / Fab) | | `invert` | `false` | – | Flip (legacy invert) | | `x` | `0.0` | μm | Finger offset in x (legacy x) | | `conn_height` | `0.5` | μm | Connector height (legacy conn_height) | | `window_height` | `10.0` | μm | Window height (legacy height) | | `y` | `0.0` | μm | Finger offset in y (legacy y) | Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows. ## LOM model none (a LOM build gives each pin its own bare node, without elements). ## How to use In Python: ```python from quantcore_circuits.designer import Designer d = Designer("demo", box=(0, 0, 7500, 7500)) d.add("U1", "JJFingerBent", at=(3750, 3750), a=10) # parameters: see the table above # no directed pin: place it with at= / rot=, or snap it with snap= / to= ``` Pin names go into `d.route(...)` as `INSTANCE.pin`, and into `snap=` / `to=` when placing. From the shell: `qcc components JJFingerBent` lists the pins; add `--schema` for the parameters. In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route. GUI status (`kplugin/COMPONENTS_STATUS.md`): places ok, edit ok, connect n/a (no directed port), build ok. no ports.