% generated by scripts/make_component_docs.py -- do not edit. Put hand-written notes in docs/components/notes/LauncherDC.md (included below). # LauncherDC The PCell declaration for a DC launcher for connecting wirebonds. **Source:** KQC (KQCircuits). **Category:** launcher. **Module:** `kqcircuits.elements.launcher_dc`. See also the [catalog](../CATALOG.md). ## Pins ![Pins of LauncherDC](../../images/components/LauncherDC.png) Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm. | pin | x (µm) | y (µm) | direction (°) | a (µm) | b (µm) | purpose | |---|---|---|---|---|---|---| | `port` | 0 | 0 | none | 10 | 6 | launcher pad (RF port); LOM node `pad` | Pins with direction `none`: `port`. They mark a point (a junction lead, a pad centre), not a CPW end. The KLayout ghost draws them as boxes. A route can start there only where the notes say so; it cannot be snapped to. a, b: CPW centre width and gap where the pin declares them (`–` = not declared). Position and direction are in the cell's own frame (`at=(0, 0)`, `rot=0`). **Notes from the catalog:** DC pad: its one port 'port' sits at the pad centre with no direction (KQC adds no corner; the square pad is symmetric). Place it with at=/rot=; a route may start or end there (it leaves toward its next node); it cannot be snapped to. For an RF launcher with a directed port use Launcher or BondPad. ## Parameters | name | default | unit | description | |---|---|---|---| | `a` | `10` | μm | Width of center conductor | | `b` | `6` | μm | Width of gap | | `r` | `100` | μm | Turn radius | | `width` | `500` | μm | Pad width | Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows. ## LOM model The cell contributes to the lumped model: | branch | type | nodes | value (estimate at defaults) | |---|---|---|---| | `Port_X` | R | pad – gnd | R_ohm=50 | Nodes: `pad`. ## How to use In Python: ```python from quantcore_circuits.designer import Designer d = Designer("demo", box=(0, 0, 7500, 7500)) d.add("U1", "LauncherDC", at=(3750, 3750), a=10) # parameters: see the table above # no directed pin: place it with at= / rot=, or snap it with snap= / to= ``` Pin names go into `d.route(...)` as `INSTANCE.pin`, and into `snap=` / `to=` when placing. From the shell: `qcc components LauncherDC` lists the pins; add `--schema` for the parameters. In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.