% generated by scripts/make_component_docs.py -- do not edit. Put hand-written notes in docs/components/notes/TaperedPad.md (included below). # TaperedPad Probe pad tapering to a junction finger (legacy "Pad"); port ``finger`` at the taper tip. **Source:** Quantcore. **Category:** test_structure. **Module:** `quantcore_circuits.layouts.others.connector_pads`. See also the [catalog](../CATALOG.md). ## Pins ![Pins of TaperedPad](../../images/components/TaperedPad.png) Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm. | pin | x (µm) | y (µm) | direction (°) | a (µm) | b (µm) | purpose | |---|---|---|---|---|---|---| | `finger` | 0 | 590 | 90 | 3 | 6 | LOM node `pad` | a, b: CPW centre width and gap where the pin declares them (`–` = not declared). Position and direction are in the cell's own frame (`at=(0, 0)`, `rot=0`). ## Parameters | name | default | unit | description | |---|---|---|---| | `a` | `10` | μm | Width of center conductor | | `b` | `6` | μm | Width of gap | | `r` | `100` | μm | Turn radius | | `pad_width` | `275` | μm | Pad width | | `pad_height` | `300` | μm | Pad height | | `finger_width` | `3` | μm | Finger (tip) width | | `window_width` | `300` | μm | Window width (legacy width) | | `conn_height` | `300` | μm | Taper length | | `negative` | `true` | – | Etch the window around the pad (legacy ground) | | `window_height` | `650` | μm | Window height (legacy height) | | `x` | `0` | μm | Pad x offset in the window | | `y` | `-10` | μm | Pad y offset in the window | Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows. ## LOM model The cell contributes to the lumped model: | branch | type | nodes | value (estimate at defaults) | |---|---|---|---| | `C_X` | C | pad – gnd | estimate=170, unit=fF, estimate_source=rough: 275×300 µm pad in a 12.5 µm clearance, estimate_kind=rough, uncertainty=±50% | Nodes: `pad`. ## How to use In Python: ```python from quantcore_circuits.designer import Designer d = Designer("demo", box=(0, 0, 7500, 7500)) d.add("U1", "TaperedPad", at=(3750, 3750), a=10) # parameters: see the table above d.add("PAD", "BondPad", at=(1125, 3750), rot=270) # a launcher to connect to d.route("L1", "PAD.a", "U1.finger") # a CPW from the pad to the pin ``` Pin names go into `d.route(...)` as `INSTANCE.pin`, and into `snap=` / `to=` when placing. From the shell: `qcc components TaperedPad` lists the pins; add `--schema` for the parameters. In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route. GUI status (`kplugin/COMPONENTS_STATUS.md`): places ok, edit ok, connect ok, build ok.