BondPad

Wire-bond pad tapering to a CPW (a/b); port a at the taper tip.

Source: Quantcore. Category: launcher. Module: quantcore_circuits.layouts.others.bond_pad.

Note

Canonical cell of an alias group. Aliases: metal:LaunchpadWirebond, metal:LaunchpadWirebondDriven, Launcher, ConnectorPad, CpweBondPad.

See also the catalog.

Pins

Pins of BondPad

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

a

0

0

90

10

6

CPW end; LOM node pad

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

pad_width

400

μm

Pad width

pad_height

450

μm

Pad height

pad_gap

225

μm

Gap around the pad

taper_length

450

μm

Taper length

rounded

false

–

Rounded pad with a 200 µm CPW stub

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

branch

type

nodes

value (estimate at defaults)

Port_X

R

pad – gnd

R_ohm=50

Nodes: pad.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "BondPad", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.a")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components BondPad lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.

GUI status (kplugin/COMPONENTS_STATUS.md): places ok, edit ok, connect ok, build ok.