CpweBondPad¶
Bond pad: open end tl, wide line bl (pad_width/pad_gap), taper btl to the CPW a/b
Source: Quantcore. Category: launcher. Module: quantcore_circuits.layouts.others.cpwe.
Note
Alias of BondPad: the same circuit, drawn differently. taper_type 0 = the Launcher polygon rotated 180° and shifted (XOR 0); taper_type 1–3 differ; port a
See also the catalog.
Pins¶

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.
pin |
x (µm) |
y (µm) |
direction (°) |
a (µm) |
b (µm) |
purpose |
|---|---|---|---|---|---|---|
|
560 |
0 |
0 |
10 |
6 |
CPW end; LOM node |
a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).
Parameters¶
name |
default |
unit |
description |
|---|---|---|---|
|
|
μm |
Width of center conductor |
|
|
μm |
Width of gap |
|
|
μm |
Turn radius |
|
|
μm |
Pad centre width (legacy wb) |
|
|
μm |
Pad gap (legacy sb) |
|
|
μm |
Open-end length (legacy tl) |
|
|
μm |
Pad length before the taper (legacy bl) |
|
|
μm |
Taper length (legacy btl) |
|
|
– |
Taper profile: 0 linear, 1–3 exponential (legacy t_type) |
|
|
– |
Exponent weight of the taper |
|
|
– |
Mirrored: taper first, pad at the +x end |
|
|
– |
Alignment crosses beside the taper end |
Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.
LOM model¶
The cell contributes to the lumped model:
branch |
type |
nodes |
value (estimate at defaults) |
|---|---|---|---|
|
R |
pad – gnd |
R_ohm=50 |
Nodes: pad.
How to use¶
In Python:
from quantcore_circuits.designer import Designer
d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "CpweBondPad", at=(3750, 3750), a=10) # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270) # a launcher to connect to
d.route("L1", "PAD.a", "U1.a") # a CPW from the pad to the pin
Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components CpweBondPad lists the pins; add --schema for the parameters.
In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.
GUI status (kplugin/COMPONENTS_STATUS.md): places ok, edit ok, connect ok, build ok.