WaveguideCoplanarSplitter¶
The PCell declaration of a multiway waveguide splitter. The number of ports is defined by the length of the
Source: KQC (KQCircuits). Category: waveguide. Module: kqcircuits.elements.waveguide_coplanar_splitter.
Note
Canonical cell of an alias group. Aliases: metal:LineTee.
See also the catalog.
Pins¶

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.
pin |
x (µm) |
y (µm) |
direction (°) |
a (µm) |
b (µm) |
purpose |
|---|---|---|---|---|---|---|
|
11 |
0 |
0 |
10 |
6 |
CPW end; LOM node |
|
-11 |
0 |
180 |
10 |
6 |
CPW end; LOM node |
|
0 |
-11 |
270 |
10 |
6 |
LOM node |
a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).
Parameters¶
name |
default |
unit |
description |
|---|---|---|---|
|
|
μm |
Width of center conductor |
|
|
μm |
Width of gap |
|
|
μm |
Turn radius |
|
|
– |
Waveguide length per port, measured from origin |
|
|
– |
Angle of each port (degrees) |
|
|
– |
Port names |
|
|
– |
Use airbridges at a distance from the centre |
|
|
– |
Bridges distance from centre |
|
|
[μm] |
Center conductor widths |
|
|
[μm] |
Gap widths |
|
|
– |
Add trace in base metal addition too |
|
|
– |
Airbridge type |
Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.
LOM model¶
The cell contributes to the lumped model:
no lumped branches
Nodes: t.
How to use¶
In Python:
from quantcore_circuits.designer import Designer
d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "WaveguideCoplanarSplitter", at=(3750, 3750), a=10) # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270) # a launcher to connect to
d.route("L1", "PAD.a", "U1.a") # a CPW from the pad to the pin
Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components WaveguideCoplanarSplitter lists the pins; add --schema for the parameters.
In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.