Flip-chip and TSV designs

A flip-chip design uses more than one metal face. KQCircuits names them by chip and side: 1t1 is the top of the bottom chip (the default face of every design), 1b1 its back side, 2b1 the face of the top chip that looks down at 1t1, and 2t1 the top chip’s back side. Indium bumps join 1t1 and 2b1; through-silicon vias (TSVs) join the two sides of one chip. This page lists what the library supports for such designs and points to the details.

Building one

  • Cells. CpwTsvTransition carries a CPW line through one chip, with port a on the front face and port b on the back face. KQC’s FlipChipConnectorRf carries a line across the bump gap, with ports a (on 1t1) and b (on 2b1). QcFlipChipConnectorRf is the same connector with a settable bump, under-bump metal and number of ground bumps. See Flip-chip and TSV cells.

  • Routes. A route takes its face from the port it starts on (or from face_ids, or a face_id waypoint that switches face mid-route). A route whose own face disagrees with its port’s face stops the build with a RoutingError.

  • LOM and netlist. Both transitions are pass-through conductors: the netlist joins the lines on either side, and the LOM sees one node. They carry no lumped inductance or capacitance of their own.

Checking it

  • DRC. Overlaps and open conductors are checked per face, so pads stacked on two faces are not an overlap, and a route on 1b1 is checked against the 1b1 etch. A via or bump is flagged only where it lands on another component’s etch on a shared face. See Faces in flip-chip and TSV designs.

  • Cheese. The PDK holes stay at least 13 µm from TSVs, bumps, under-bump metal and airbridges. The cheese is drawn on face 1t1 only.

  • Pictures. The whole-chip picture draws every face on one plane, so a bump or via can look as if it sits on a line that runs on another face. Only shapes on the same face touch, and the DRC compares them face by face. In the TSV flip-chip test chip, 20 ground bumps lie under the top chip’s backside serpentines in the top-down view, with the whole top chip between them.

Simulating it

A sim group that crosses a bump or a TSV exports with every face it uses: the faces are found from its routes and cells, and the job gets KQC’s face stack with the PDK chip gap (8 µm, KQC’s default; not a measured Quantcore value). Bumps and TSVs become conductors that join the faces. One-face groups export exactly as before. See Flip-chip and TSV sim groups.

Fab export

The fab layer map writes faces 1t1 and 2b1 (the top chip on 800–804/0), TSVs on 700/0 and bumps on 801/0 and 802/0. The back faces 1b1 and 2t1 have no fab layer yet: export_fab leaves them out with a FabLayersDropped warning. See Fab export.

Not supported yet

  • Junction ports on any face other than 1t1.

  • More than two chips.

  • A solved multi-face FEM run: the jobs export and pass the geometry check, but none has been run in AEDT.

  • Lumped values for the transitions themselves (via height, bump, width steps).

Worked example

The TSV flip-chip test chip runs two CPW lines through all four faces with these cells, and the two-face Demo chip splits a four-qubit chip over a flip chip.