CircularCapacitor

The PCell declaration for a circular capacitor.

Source: KQC (KQCircuits). Category: capacitor. Module: kqcircuits.elements.circular_capacitor.

See also the catalog.

Pins

Pins of CircularCapacitor

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

a

-100

0

180

10

6

CPW end; LOM node a

b

100

0

0

10

6

CPW end; LOM node b

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

swept_angle

180

–

Angle covered by the external island in degrees

outer_island_width

40

μm

External island width

ground_gap

20

μm

Ground plane padding

fixed_length

0

μm

Fixed length of element, 0 for auto-length

r_inner

20

μm

Internal island radius

r_outer

80

μm

External island radius, measured at the outer edge

a2

-1

μm

Width of center conductor on the other end

b2

-1

μm

Width of gap on the other end

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

branch

type

nodes

value (estimate at defaults)

C_X

C

a – b

estimate=8, unit=fF, estimate_source=rough: disk–arc gap 20 µm over 94 µm (CPS), estimate_kind=rough, uncertainty=±50%

C_X_a

C

a – gnd

estimate=4.9, unit=fF, estimate_source=rough: free disk edge / arc outer edge (half CPW), estimate_kind=rough, uncertainty=±50%

C_X_b

C

b – gnd

estimate=24, unit=fF, estimate_source=rough: free disk edge / arc outer edge (half CPW), estimate_kind=rough, uncertainty=±50%

Nodes: a, b.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "CircularCapacitor", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.a")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components CircularCapacitor lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.