quantcore_circuits.layouts.junctions.sim_gap

KQC "Sim" junction across a plain etched gap (the simulation stand-in of a drawn junction).

Simulation builds set junction_type = "Sim": KQC’s Sim draws two 8 µm wide metal pads, the lower one junction_lower_pad_length up from its origin and the upper one junction_upper_pad_length down from junction_total_length; the junction port is the gap between them (port_squid_b = top of the lower pad, port_squid_a = bottom of the upper pad).

A qubit whose junction bridges a gap between two metal edges (Flipmon disc ↔ ring, TransmonTaperedInsets taper tips) used to place it with junction_total_length = gap and KQC’s default 12 + 13 µm pads. Two failures followed:

  • a gap below 25 µm (both cells’ defaults: 20 µm) makes the pads overlap — the islands are one conductor, the port points lie inside metal (KQC: Unable to create polygon for port) and the C-matrix loses an island;

  • the pads end exactly on the island edges: on a curved edge (the Flipmon disc) the pad touches the island at a single polygon vertex. KQC counts that as connected (Region.interacting), Q3D does not: AutoIdentifyNets splits the net and Q3D stops with Object '…signal_1_2' in Net 'Net1' and object '…signal_1_3' … are touching.

sim_junction_in_gap() gives the pads SIM_PAD_OVERLAP_UM of overlap into the metal on both sides (merged with the island, so a straight edge looks the same as before) and keeps KQC’s 12 / 13 µm in the gap while that leaves at least KQC’s own 8 µm port; a narrower gap gets a min(8, gap / 2) µm port in the middle. Only the "Sim" junction changes: fab junctions (and so every chip build) are untouched.

Attributes

Functions

sim_junction_in_gap(gap[, overlap]) → tuple[float, dict]

(shift, params) of a KQC Sim junction across a gap µm wide etched gap.

Module Contents

quantcore_circuits.layouts.junctions.sim_gap.sim_junction_in_gap(gap: float, overlap: float = SIM_PAD_OVERLAP_UM) → tuple[float, dict]

(shift, params) of a KQC Sim junction across a gap µm wide etched gap.

params go to produce_squid; place the junction shift µm back into the metal on the origin side, i.e. trans * pya.DCplxTrans(1, 0, False, 0, -shift) where trans puts the origin on that gap edge with +y across the gap. include_background_gap is off: the cell has already etched the gap (KQC’s 18 µm background box would notch both islands where the pads now enter them).

quantcore_circuits.layouts.junctions.sim_gap.SIM_PAD_OVERLAP_UM = 2.0
quantcore_circuits.layouts.junctions.sim_gap.SIM_PORT_UM = 8.0