TaperedPad

Probe pad tapering to a junction finger (legacy “Pad”); port finger at the taper tip.

Source: Quantcore. Category: test_structure. Module: quantcore_circuits.layouts.others.connector_pads.

See also the catalog.

Pins

Pins of TaperedPad

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

finger

0

590

90

3

6

LOM node pad

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

pad_width

275

μm

Pad width

pad_height

300

μm

Pad height

finger_width

3

μm

Finger (tip) width

window_width

300

μm

Window width (legacy width)

conn_height

300

μm

Taper length

negative

true

–

Etch the window around the pad (legacy ground)

window_height

650

μm

Window height (legacy height)

x

0

μm

Pad x offset in the window

y

-10

μm

Pad y offset in the window

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

branch

type

nodes

value (estimate at defaults)

C_X

C

pad – gnd

estimate=170, unit=fF, estimate_source=rough: 275×300 µm pad in a 12.5 µm clearance, estimate_kind=rough, uncertainty=±50%

Nodes: pad.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "TaperedPad", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.finger")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components TaperedPad lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.

GUI status (kplugin/COMPONENTS_STATUS.md): places ok, edit ok, connect ok, build ok.