GatemonCoupler

Straight CPW o1 → o2 with a capacitive island reference port qubit (QPDK gatemon_coupler).

Source: Quantcore. Category: coupler. Module: quantcore_circuits.layouts.others.qpdk_cells.

See also the catalog.

Pins

Pins of GatemonCoupler

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

o1

0

0

180

10

6

LOM node line

o2

600

0

0

10

6

LOM node line

qubit

200

-45

270

150

40

LOM node qubit

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Notes from the catalog: QPDK gatemon_coupler (MIT). Port ‘qubit’ is a capacitive reference plane (a = island_width, b = pocket_gap_top), not a CPW end: snap a Gatemon ‘readout’ to it.

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

length

600

μm

Line length

coupling_position

200

μm

Island centre measured from o1

island_width

150

μm

Island width (reference plane)

pocket_gap_top

40

μm

Island edge to conductor edge

coupling_capacitance

5.4

fF

Nominal line-island capacitance (LOM)

qubit_side

"bottom"

–

Island side of the line

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

branch

type

nodes

value (estimate at defaults)

Cg_X

C

line – qubit

estimate=5.4, unit=fF, estimate_source=rough: QPDK nominal coupling_capacitance (cell parameter), estimate_kind=rough, uncertainty=±50%

line

node

length (µm)

a (µm)

b (µm)

ends

X

line

600

10

6

short / short

Nodes: line, qubit.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "GatemonCoupler", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.o1")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components GatemonCoupler lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.

GUI status (kplugin/COMPONENTS_STATUS.md): places ok, edit ok, connect ok, build ok.