quantcore_circuits.layouts.others.bond_pad

Bond pad with CPW taper (ported from QWri Connector Pad 2, fab mode).

Local frame: taper tip (CPW end) at the origin, pad body below it; port a faces +y. The pad’s ground-side edge (the bottom of the gap below the pad) is at y = -(pad_height + taper_length + pad_gap) for the square pad, which is where the legacy chips put the chip edge. Geometry is the legacy fab output, computed with the same pya calls.

Classes

BondPad

Wire-bond pad tapering to a CPW (a/b); port a at the taper tip.

Functions

connector_pad_gaps(dbu, pad_width, pad_gap, ...)

Legacy ConnectorPad2.makePAD with fab=True, sim=False, returned in dbu (already shifted to the tip).

Module Contents

class quantcore_circuits.layouts.others.bond_pad.BondPad

Bases: kqcircuits.elements.element.Element

Wire-bond pad tapering to a CPW (a/b); port a at the taper tip.

Ported from the legacy QWri PCell Connector Pad 2 (pymacros/QuantumPcells/connector_pad_v2.lym), fab mode. Refpoints pad_center, chip_edge and lumped_signal / lumped_ground (the simulation lumped port across the side gap at the pad centre).

build()
classmethod qcc_keepout(params: dict) → list

3/0 keep-out (local µm), legacy connector_pad_v2.lym fab_l: the 1/0 etch grown by 50 µm in x.

classmethod qcc_lom(name: str, inst, pdk)

A bond pad is a 50 Ω port to ground on whatever conductor its a port connects to.

pad_gap
pad_height
pad_width
qcc_category = 'launcher'
rounded
taper_length
quantcore_circuits.layouts.others.bond_pad.connector_pad_gaps(dbu, pad_width, pad_gap, pad_height, conn_height, trace_width, trace_gap, rounded)

Legacy ConnectorPad2.makePAD with fab=True, sim=False, returned in dbu (already shifted to the tip).