quantcore_circuits.layouts.chips.design_chip

DesignChip: a KQC Chip that executes a resolved build plan.

All decisions (snap transforms, routes, fixed lengths, parameter inheritance) are made beforehand by quantcore_circuits.assembly.plan.plan_design(), outside the PCell. KLayout swallows exceptions raised inside PCell code, so this class only replays the plan; KQC’s Chip.post_build then adds frame, ground grid and layer merging as usual.

Attributes

Classes

DesignChip

Chip generated from a design.json build plan.

Functions

ensure_registered()

Make sure DesignChip (and all Quantcore cells) are registered in the KQC libraries.

launcher_indent(kw, edge) → float

KQC launcher_indent (die edge → launcher port) that puts a launcher's outer etch edge edge µm from the

Module Contents

class quantcore_circuits.layouts.chips.design_chip.DesignChip

Bases: kqcircuits.chips.chip.Chip

Chip generated from a design.json build plan.

build()
post_build()

KQC’s post_build (frames, ground TSVs and bumps, labels); then the PDK cheese drawn in build() loses the holes that now lie on or next to KQC’s automatic ground TSVs and bumps (with_gnd_tsvs, with_gnd_bumps), which KQC places after the build.

produce_ground_grid()

KQC grids only faces with a KQC ChipFrame; with the PDK die frame, grid the design area instead, clear of the marker areas and the device ID.

cheese
device_id_side
die_frame
instance_label_height
name_brand
plan
qcc_category = 'chip'
quantcore_circuits.layouts.chips.design_chip.ensure_registered()

Make sure DesignChip (and all Quantcore cells) are registered in the KQC libraries.

quantcore_circuits.layouts.chips.design_chip.launcher_indent(kw: dict, edge: float) → float

KQC launcher_indent (die edge → launcher port) that puts a launcher’s outer etch edge edge µm from the die edge: RF Launcher = taper (width) + pad (width) + frame gap; LauncherDC = half its 100 µm-wider gap square.

quantcore_circuits.layouts.chips.design_chip.KQC_LABEL_HEIGHT = 280.0
quantcore_circuits.layouts.chips.design_chip.LABEL_CAP_RATIO = 0.7