CpweTaper

Taper from a/b to a_end/b_end (legacy cpwe.tapper: linear or exponential profiles).

Source: Quantcore. Category: waveguide. Module: quantcore_circuits.layouts.others.cpwe.

Note

Alias of WaveguideCoplanarTaper: the same circuit, drawn differently. linear profile (taper_type 0): length → taper_length, a_end → a2, b_end → b2; ports a, b (XOR 0.03 of 565 µm², dbu rounding). The exponential profiles 1–3 have no KQC drawing (same LOM: mean a/b)

See also the catalog.

Pins

Pins of CpweTaper

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

a

0

0

180

10

6

CPW end; LOM node line

b

100

0

0

20

12

CPW end; LOM node line

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

length

100

μm

Taper length

taper_type

0

–

Profile: 0 linear, 1–3 exponential (legacy t_type)

a_end

20

μm

Centre width at the +x end

b_end

12

μm

Gap at the +x end

weight

25

–

Exponent weight

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

  • no lumped branches

line

node

length (µm)

a (µm)

b (µm)

ends

X

line

100

15

9

short / short

Nodes: line.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "CpweTaper", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.a")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components CpweTaper lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.

GUI status (kplugin/COMPONENTS_STATUS.md): places ok, edit ok, connect ok, build ok.