FlipChipConnectorRf

PCell declaration for an inter-chip rf connector.

Source: KQC (KQCircuits). Category: flip_chip. Module: kqcircuits.elements.flip_chip_connectors.flip_chip_connector_rf.

See also the catalog.

Pins

Pins of FlipChipConnectorRf

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

a

-60

0

180

10

6

CPW end; LOM node line

b

60

0

0

10

6

CPW end; LOM node line

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Notes from the catalog: KQC names its CPW ends ‘_port’: qcc gives them as port ‘a’ (face_ids[0], CPW a/b) and ‘b’ (face_ids[1], a2/b2), each recording its face, so a route ends on them on that face (registry.KQC_EXTRA_PORTS). KQC always draws a 25 µm bump on a 40 µm UBM and 4 ground bumps; QcFlipChipConnectorRf sizes them. LOM: one conductor through the bump.

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

inter_bump_distance

100

μm

Distance between In bumps

output_rotation

180

degrees

Rotation of output port w.r.t. input port

connector_a

40

μm

Conductor width at the connector area

connector_b

40

μm

Gap width at the connector area

round_connector

false

–

Use round connector shape

n_center_bumps

1

–

Number of center bumps in series

bump_type

"Flip Chip Connector Dc"

–

Bump type

a2

-1

μm

Width of center conductor on the other end

b2

-1

μm

Width of gap on the other end

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

  • no lumped branches

line

node

length (µm)

a (µm)

b (µm)

ends

X

line

120

10

6

short / short

Nodes: line.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "FlipChipConnectorRf", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.a")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components FlipChipConnectorRf lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.