CpwResonator

Meandered CPW resonator grounded at both ends (legacy CPW Resonator); ports start and end.

Source: Quantcore. Category: resonator. Module: quantcore_circuits.layouts.others.legacy_resonators.

See also the catalog.

Pins

Pins of CpwResonator

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

end

389

-381.972

0

10

6

far end of the line / resonator (see the notes); LOM node res

start

-12

0

180

10

6

LOM node res

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

width

500

μm

Meander width (straight run between arcs)

arc_length

100

μm

Arc length of a meander turn (radius = arc_length / π)

neck_length

100

μm

Neck length

cgap

6

μm

Coupling gap (ground strip around the shorted end)

tail_length

100

μm

Tail length

cpw_len

4000

μm

Length of the resonator

arc_points

256

–

Points per arc (legacy n)

tail

false

–

Tail

mid_tail

false

–

Tail in the middle

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

  • no lumped branches

line

node

length (µm)

a (µm)

b (µm)

ends

X

res

4011.996

10

6

short / short

Nodes: res.

  • X: coupling to a feedline is not in the cell; declare it with d.couple(…)

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "CpwResonator", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.end")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components CpwResonator lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.

GUI status (kplugin/COMPONENTS_STATUS.md): places ok, edit ok, connect ok, build ok.