HangerResonator

Hanger Resonator

Source: KQC (KQCircuits). Category: resonator. Module: kqcircuits.elements.hanger_resonator.

See also the catalog.

Pins

Pins of HangerResonator

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

a

0

0

180

10

6

CPW end; LOM node pl

b

500

0

0

10

6

CPW end; LOM node pl

resonator_a

-100

-274.92

270

10

6

LOM node res

resonator_b

600

-174.92

270

10

6

LOM node res

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

coupling_length

500

μm

Length of the resonator center part (coupling)

head_length

300

μm

Length of the resonator left waveguide (head)

resonator_length

1000

μm

Total length of the resonator

ground_width

10

μm

Trace width of middle ground

res_a

10

μm

Trace width of resonator line

res_b

6

μm

Gap width of resonator line

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

  • no lumped branches

line

node

length (µm)

a (µm)

b (µm)

ends

X

res

1000

10

6

short / short

Nodes: pl, res.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "HangerResonator", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.a")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components HangerResonator lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.