WaveguideCoplanarCurved

The PCell declaration of a curved segment of a coplanar waveguide.

Source: KQC (KQCircuits). Category: waveguide. Module: kqcircuits.elements.waveguide_coplanar_curved.

Warning

Legacy cell. the bare arc piece routes are drawn with; unused as a cell. Use a route (its bends). Ports a/b and a line LOM since 2026-11-15

See also the catalog.

Pins

Pins of WaveguideCoplanarCurved

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

a

100

0

270

10

6

CPW end; LOM node line

b

-100

0

270

10

6

CPW end; LOM node line

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Notes from the catalog: origin at the arc centre: port ‘a’ at (r, 0), ‘b’ at angle alpha, both facing out along the tangent (registry.KQC_EXTRA_PORTS; KQC draws no ports). LOM: a CPW line of r·|alpha|.

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

length

0

μm

Actual length

ground_grid_in_trace

false

–

Add ground grid also to the waveguide

alpha

3.141592653589793

–

Curve angle (rad)

add_metal

false

–

Add trace in base metal addition too

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

  • no lumped branches

line

node

length (µm)

a (µm)

b (µm)

ends

X

line

314.159

10

6

short / short

Nodes: line.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "WaveguideCoplanarCurved", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.a")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components WaveguideCoplanarCurved lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.