WaveguideCoplanarTaper

The PCell declaration of a taper segment of a coplanar waveguide.

Source: KQC (KQCircuits). Category: waveguide. Module: kqcircuits.elements.waveguide_coplanar_taper.

Note

Canonical cell of an alias group. Aliases: CpweTaper.

See also the catalog.

Pins

Pins of WaveguideCoplanarTaper

Pin image (default parameters). Light = metal, dark = etched gap, colours = junction layers. A red dot and arrow is a pin and its direction (out of the cell); the red bar is the CPW width a + 2 b. Blue dot = a pin without direction. Units: µm.

pin

x (µm)

y (µm)

direction (°)

a (µm)

b (µm)

purpose

a

0

0

180

10

6

CPW end; LOM node line

b

31.416

0

0

20

12

CPW end; LOM node line

a, b: CPW centre width and gap where the pin declares them (– = not declared). Position and direction are in the cell’s own frame (at=(0, 0), rot=0).

Parameters

name

default

unit

description

a

10

μm

Width of center conductor

b

6

μm

Width of gap

r

100

μm

Turn radius

taper_length

31.41592653589793

μm

Taper length

m2

10

μm

Margin of right waveguide protection layer

a2

20

μm

Width of center conductor on the other end

b2

12

μm

Width of gap on the other end

add_metal

false

–

Add trace in base metal addition too

Electrically relevant parameters (sizes, gaps, junction, ports) come first, the rest follows.

LOM model

The cell contributes to the lumped model:

  • no lumped branches

line

node

length (µm)

a (µm)

b (µm)

ends

X

line

31.416

15

9

short / short

Nodes: line.

How to use

In Python:

from quantcore_circuits.designer import Designer

d = Designer("demo", box=(0, 0, 7500, 7500))
d.add("U1", "WaveguideCoplanarTaper", at=(3750, 3750), a=10)   # parameters: see the table above
d.add("PAD", "BondPad", at=(1125, 3750), rot=270)   # a launcher to connect to
d.route("L1", "PAD.a", "U1.a")                # a CPW from the pad to the pin

Pin names go into d.route(...) as INSTANCE.pin, and into snap= / to= when placing. From the shell: qcc components WaveguideCoplanarTaper lists the pins; add --schema for the parameters.

In KLayout: Quantcore panel ▸ Components ▸ double-click the cell, then click on the layout to place it. Rotate and mirror before the click; use Connect on two pins to route.